- Update the partition sizes to match the needs of a workstation;

128MB for / instead of 100MB and 256MB instead of 50MB for /var
  (this size is a bit above the minimal size proposed by the automatic
  sizing algorithm);
- Update the / partition creation to really use the same size as the
  one given in the partition layout discussion;
- Update sysinstall messages for the mouse configuration.

en_US.ISO8859-1/books/handbook/install/chapter.sgml

@@ -947,7 +947,7 @@ Insert disk labelled "Kernel floppy 1" and press any key...</screen>
 	    </mediaobject>
 	  </figure>
 
-	  <para>Either wait ten seconds, or press <keycap>Enter</keycap></para>
+	  <para>Either wait ten seconds, or press <keycap>Enter</keycap>.</para>
 	</step>
       </procedure>
 
@@ -1781,10 +1781,10 @@ Mounting root from ufs:/dev/md0c
 
 	      <entry><filename>/</filename></entry>
 
-	      <entry>100&nbsp;MB</entry>
+	      <entry>128&nbsp;MB</entry>
 
 	      <entry>This is the root filesystem.  Every other filesystem
-		will be mounted somewhere under this one.  100&nbsp;MB is a
+		will be mounted somewhere under this one.  128&nbsp;MB is a
 		reasonable size for this filesystem.  You will not be storing
 		too much data on it, as a regular FreeBSD install will put
 		about 40&nbsp;MB of data here.  The remaining space is for temporary
@@ -1823,7 +1823,7 @@ Mounting root from ufs:/dev/md0c
 
 	      <entry><filename>/var</filename></entry>
 
-	      <entry>50&nbsp;MB</entry>
+	      <entry>256&nbsp;MB</entry>
 
 	      <entry>The <filename>/var</filename> directory contains
 		files that are constantly varying;
@@ -2028,7 +2028,7 @@ Mounting root from ufs:/dev/md0c
 	rest of the slice.  If you are using the partition sizes described
 	in the earlier example, then delete the existing figure using
 	<keycap>Backspace</keycap>, and then type in
-	<userinput>64M</userinput>, as shown in 
+	<userinput>128M</userinput>, as shown in 
 	<xref linkend="sysinstall-label-add2">.  Then press
 	&gui.ok;.</para>
       
@@ -3023,11 +3023,11 @@ Press [Enter] now to invoke an editor on /etc/exports
 	non-USB mouse configuration (such as a PS/2 or COM port mouse):</para>
 
       <screen>                      User Confirmation Requested 
-         Does this system have a non-USB mouse attached to it?
+         Does this system have a PS/2, serial, or bus mouse?
 
                             [ Yes ]    No </screen>
 
-      <para>Select &gui.yes; for a non-USB mouse or
+      <para>Select &gui.yes; for a PS/2, serial or bus mouse, or
 	&gui.no; for a USB mouse and press
 	<keycap>Enter</keycap>.</para>